Chapter 1: Pre-Inspection Preparation
Before arriving at the construction site, every inspector must ensure they are equipped and legally prepared.
1
Safety Gear (PPE)
Ensure you have your hard hat, safety boots, reflective vest, and protective eyewear. No PPE, No Entry.
2
Documentation Review
Review the approved building plans, previous inspection reports, and structural drawings. Note critical load-bearing points.
3
Tools Check
Verify calibration of Schmidt Hammer, Rebar Scanner, Laser Distometer, and Digital Camera.
Chapter 2: Foundation Inspection
The stability of the entire structure rests on the foundation. This stage is critical.
1
Soil Stratification
Compare excavated soil with the Geotechnical Report. Look for signs of water table issues or loose fill.
2
Dimension Check
Verify depth and width of trenches/footings against structural drawings.
Chapter 3: Concrete Quality Control
Procedures for Slump Test and Cube Test sampling...
Chapter 4: Reinforcement Checks
Verifying bar diameter, spacing, and cover...
Chapter 5: Identifying Structural Cracks
Distinguishing between shear, flexural, and shrinkage cracks...
Chapter 6: Reporting Protocols
How to file a Non-Compliance Notice (NCN) and Stop Work Order...